資源描述：
《JJG953-2000精密時間間隔測量?jī)x檢定規程.pdf》由會員上傳分享，免費在線閱讀，更多相關內容在應用文檔-天天文庫。
1、中華人民共和國國家計量檢定規程JJG953-2000精密時間間隔測量?jī)xPrecisionTimeIntervalMeter2000一07一09發布2000一09一15實施國家質量技術監督局發布JJG953-2000精密時間間隔測量?jī)x檢定規程口·。.偽0.~~補補0.~~一心D弓VerificationRegulationofPrecisionJJG953-2000、。。。。。一。.o.o.o.o.o.o.o.o.}TimeIntervalMeter本規程經國家質量技術監督局2000年07月09日批準，并自2000年09月15日起施行。歸口單位:全國時間頻率計量
2、技術委員會主要起草單位:信息產業部通信計量中心參加起草單位:中國計量科學研究院本規程由全國時間頻率計量技術委員會負責解釋JJG953-2000本規程主要起草人:周波(信息產業部通信計量中心)參加起草人:馬鳳鳴(中國計量科學研究院)陳振恒(信息產業部通信計量中心)d7G953-2000目錄1范圍············································································?！ぁぁぁぁぁぁぁぁぁぁぁぁぁぁ?、、二(1)2概述···4·······················，·······
3、·······················································??(1)3計量性能要求···································································?！ぁぁぁぁぁぁぁぁぁ??(1)4通用技術要求···················?！ぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁ??(2)5計量器具控制····································
4、······················。···················??(2)6檢定條件··················，··························?！ぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁぁ??(2)7檢定項目及檢定方法·····································································??(3)7.1外觀及工作正常性檢查·············································
5、··················??(3)7.2內部晶振各項指標的檢定························································，·、··、·?(3)7.3時間間隔測量不確定度的檢定······················································??(3)7.4時間間隔測量范圍的檢定··············································?！ぁぁぁぁぁぁぁぁぁぁぁぁ??(4)8檢定結果的處理及檢定周期·...........
6、......................................................(5)附錄檢定證書內面格式·.......................................................................(6)JJG953-2000精密時間間隔測且儀檢定規程范圍本規程適用于最小間隔為1ns的精密時間間隔測量?jī)x的首次檢定和后續檢定。2概述精密時間間隔測量?jī)x測量時，將被測間隔分為兩部分:大于一個時基的部分，采用普通數字式時間間隔測量?jī)x的原理，即累計時基脈沖的個數;小于一個時基的部分，用模擬內
7、插法、數字游標法或模/數(A/D)變換法進行。測量分辨力理論上可達幾個ps,但實際上由于噪聲的影響，造成測量顯示不穩定，目前只能做到100pso精密時間間隔測量?jī)x(以下簡稱測量?jī)x)，廣泛地用在計量、通訊、高能物理等領域。計t性能要求3.1內部晶振3.1.1日老化率:優于1x10-83.1.2開機特性:優于3x10-83.1.3頻率準確度:優于1x10一”3.1.4頻率穩定度:優于1x10-10/1s3.2時間間隔測量3.2.1被測信號形式:兩個正脈沖、兩個負脈沖、一個正(負)脈沖與一個負(正)脈沖間的時間間隔;單個正、負脈沖的寬度。3.2.2被測信號電平:TT
8、L.3.2.3測量范圍:1ns-10s
